The motor axle doesn't fit in the forks

It's very important for motor wheels to be snug inside the bike forks - therefore we supply a standard 10mm flat with our motor wheels, because bike forks are usually 10mm wide or less.

 

 

If your fork slots are less than 10mm, thats not a problem, the best thing to do is bit by bit, file down the flats on the motor axle.

 

The best strategy is to file a bit and then try to fit the wheel to avoid over-filing, please refer to section 6.3 in the instruction manual for further guidance. Manual linked here

 

 

Was this article helpful?
2 out of 4 found this helpful